Select a different country or region to see content for your location.
United States
Idler Pulley Units
Idler pulley units are tensioning systems for belt drives and idler units.
They:
The ready-to-fit units comprise deep drawn, profiled sheet steel pulley halves riveted together and deep groove ball bearings. Pulleys of larger diameters are additionally welded together. A lead chamfer on the pulley profile prevents damage to the belt. Due to the sheet steel construction, the additional rotating masses and the out-of-balance masses generated are low.
Type A is suitable for V-belts, type B for flat, V and round belts, type D for round belts, steel cables and hemp ropes.
They:
- increase the wrap angle in belt drives and can therefore support higher power levels or allow smaller units to be used
- Compensate for belt stretch resulting from operation
- Allow shorter center distances
- Reduce the wear on the belt drive
The ready-to-fit units comprise deep drawn, profiled sheet steel pulley halves riveted together and deep groove ball bearings. Pulleys of larger diameters are additionally welded together. A lead chamfer on the pulley profile prevents damage to the belt. Due to the sheet steel construction, the additional rotating masses and the out-of-balance masses generated are low.
Type A is suitable for V-belts, type B for flat, V and round belts, type D for round belts, steel cables and hemp ropes.
Please wait...
Idler Pulley Units
No results found
Searching for the term did not yield any result. \nTry searching for another term or check if you have entered the correct term
Contact us